What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 27.06.2025 02:12
These are simplified answers to the original question, and does not change anything I wrote above.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
But… the neutral is now “floating” because of the 1 ohm resistance.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Edit 2024–10.
It also is a device that limits the change in current flow.
Barnstars:
What does a fuse do?
[old diagram got deleted by accident]
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
2024–10–10[John johnson John Johnson ]
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
The bolt then partially travels down the line to your home.
Est ad incidunt reiciendis ut aut.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
A fuse is a non-resetable over current circuit protector.
For this case there are devices called Metal oxide varistors (MOV).
What’s the saddest thing you’ve seen at your job?
a photo is worth a thousand words.
These devices are installed between the “hot” and “neutral” and protective ground.
One is “what exactly is in a ‘surge protector’ ? ”
This device then solves the entire problem.
At one ohm, the resistor has a maximum of 1 watt power.
A circuit breaker is similar, but is resettable.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
"Sixth sense" found in animals, changing science's view of sound - Earth.com
The other is “what does a “fuse” do?”
so, what happens?
The third is lightning and “how it gets conducted into a home.”
What was your most memorable combat mission during the Vietnam War?
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
This is 'the assistant's answer'
2024–10–16 [ OO OLAOYE OYEBODE ]
He then describes Rainy Season and Lightning.
He then describes the function of a fuse.
This is where the MOV conducts again, and dissipated the energy.
How does a new KDP writer supposed to market a book?
In schematic diagrams this is the symbol for a fuse:
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
There are two important concepts here.
Recursion lays off 20% of staff in wake of pipeline cutbacks - Fierce Biotech
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
At least they know the answer if they wanted it.
what exactly is a ‘surge’ protector?
This one hit behind the barn.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Upvotes:
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
He then asserts :
(Dc diagram shown, AC is similar).
What is lightning?
But it can get overloaded, and no longer works.
There are three different concepts here that are getting confused.
An AC voltage/ current source, and an ac inductive load.
Now when you have a certain ac resistance, then a current flows in a loop.
the problem then depends on "how fast does the fuse operate?".
eight
[image of Common-mode choke]
nine
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
but this device (an Inductor) … impedes the rapid changes in the current.
First Sentence:
This is the picture of an electronic coil of wire wound around a core of magnetic material.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–10–14 [Omar Gharbi Omar Gharbi ]
Can the fuse protect the electronic devices from lightning instead of a surge protector.
So, the voltage could go up to 500 volts, and the fuse will not open up.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
but I think this circuit , shows a few more pieces.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Here is a simplified AC power diagram.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
One
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
The MOV will conduct when the voltage exceeds 50% of line voltage.
I post the exact comment here.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
It seems Mohan does not understand the difference between a comment and an Answer.
Because the load is inductive, the current lags the voltage.(by a bit).
This is where this question deviates from being a 'generic' question, and becomes more specific.